Improve the way you apply texture using the better alternative to hopper guns or can spray texture from EZ-PRO Texture in Corona, CA.

A NEW TEXTURE SYSTEM FOR PATCH AND REPAIR/SMALL REMODEL

 Now With a New and Improved "ODORLESS" Formula.


VIRTUALLY ZERO 

Setup OR Cleanup

60 PSI for Orange Peel, 30 PSI for Knockdown

 
   

 


   
Basic Instructions for EZ Pro Texture Gun and Ready Mix Texture in a Bag
Please read these instructions completely before using this product.
First and foremost, ALWAYS remember to shake the bag before spraying.

The recommended air pressure from your compressor should be 60 psi (2.5 cfm) for Orange Peel, 30 psi for Knockdown, with a minimum 100 psi compressor. You can adjust the air to your liking as you become more familiar with the gun. For instance, you can leave the air set at 60 psi on your regulator and acheive the correct psi for Knockdown simply by closing the brass know on the back of the gun until it is almost completely closed. This will result in very little trigger action, but it will reduce the air flow for Knockdown without having to change it at your regulator. This requires getting a feel for the gun somewhat, but definitely an option.

Once your air is set on your compressor regulator, and your bag is applied to your gun, you are now ready to start spraying. First squeeze the trigger and get the air flowing while moving the gun in a circular motion. THEN squeeze the bag to push texture up into the air stream. But make sure you start with air first. Otherwise you will force texture into the chamber, and when you hit it with air it will splatter inconsistently. So again,,, ALWAYS, Air First, THEN squeeze the bag while keeping the gun moving in a circular motion the entire time.  
When using a completely full bag, slightly pinch the bag just below the spout at the top of the bag to limit the amount of texture being pulled from the bag when you first start spraying. This is especially important if you want a very fine Level 5 texture. If nothing is coming out, slightly release the pressure on your fingers while keeping the gun moving. Keep releasing your pinch until you are spraying the desired pattern. Soon the Venturi effect (pulling of texture from the bag) will decrease the amount of texture being pulled from the bag and you will need to start squeezing the bag to spray texture.    
Orange Peel: When shooting all levels of Orange Peel, set your regulator to 60 psi and open the brass knob on the back of the gun a full three or four complete turns (turning counter clockwise). Keep the gun moving in a circular motion, pull the trigger, and let the air start pulling a slight amount of texture out of the bag (pinch if necessary), then start applying pressure to the bag (squeeze the bag) to force out more or less texture to match what you are repairing. Always start light, then build it up to the desired amount. You control how much or how little texture is being applied simply by squeezing the bag as you spray. That gives you tremendous flexibility to match whatever texture you are repairing, all with the same tip…
Knockdown: There is a slight learning curve when shooting Knockdown, as in any trade application, but it can be picked up in no time. First, set your air at the regulator to 30 psi. Once you have the air set, and while you are pulling the trigger, start squeezing the bag and keep the gun moving. You’ll need to be closer to the wall for Knockdown. The harder you squeeze the bag the heavier your texture will be. Just be sure and keep the gun moving or you will load up too much in one area. Remember, the thicker you’re desired Knockdown, the harder you have to squeeze. As stated earlier there is a slight learning curve with Knockdown. Just practice a little and you’ll be spraying perfect Knockdown in no time. But remember, shake the bag before spraying, and ALWAYS, air first, then squeeze the bag.

Please call customer service with any questions: 800-991-6447 Ext:200

We are ALWAYS here to help!

PATENT PENDING

"THE EZ WAY TO SPRAY"

We didn't invent drywall texture,

we just made it EZ!!!

 


EZ-PRO TEXTURE Products 

EZ-PRO TEXTURE Gun

Ready Mix Texture 10/CASE

Single Bag

PURCHASE TODAY ON OUR ONLINE STORE